With the latest build - when you start it from the console gives you an interactive cli shell.
The cli shell's interpreter is the same as the http service api.
is the same as
/runtime/ls in the shell
Birdy Cam is getting ready for the Winter...
This is an ESP32 Cam being fed into MRL's OpenCV service, streaming Mpeg with URL (plus Motion Detect Filter).
If you have an ESP32 Cam then it is HIGHLY recommended to install a good antenna (see below).
For point of cost reference ESP32Cam is circa $6 (one bag of sunflower seeds also circa $6).
I have been running mrl for several months and all is well with it. I can edit the config files and set up my servos.
I want to move on to InMoov2
In what directory are the config files in inmoov2 to edit min max rest etc for the servos
For example the head?
I have tried editing the files in C:\mrl\myrobotlab\resource\InMoov2\config\ skeleton_head.config.default but the changes do not show up when I start the program using START_Temporary.bat
I will use for tracking the motion of a person the Lidar X4.
In the first step, I try to install ROS on my Raspberry 3b+, but in Linux it's not so easy as it seems.
Did anyone has experiences with lidars or ROS to share ?
Je rencontre, depuis peu, un problème de communication entre myrobotlab et une de mes cartes arduino.
j'ai fait un No-worky, je ne sais pas quelle suite donner.
A pretty fun diversion (squirrel !), Listening to country music ... that seems to be most common in the lower frequency bands with a RTL-SDR
Gareth turned me on to it. Linux install was pretty straight forward. Digital packet over low band ... hmmmm.... slow but nice range
Hello gents! I was wondering if anyone has had any results on getting the Leap motion service up and working on the latest version of manticore? I am running via a PC incase that helps solve anything. I read that mac requires a little bit more set up to get leap motion working but not really sure. :9