Next version 'Nixie' is coming soon !

Help us to get ready with MyRobotLab version Nixie: try it !

Hello All, 

I'm trying out Nixie and I have questions. 

1. I'm running Nixie MRL in Ubuntu 18.04,  do I have to type in "java -jar myrobotlab.jar" to launch MRL every single time?   I find that I have saved configs but everytime I launch it in the above way.....the configs are being reset and I have to set it again and again...., is there something I'm doing wrong to relaunch MRL? 

When i install in the latest version of MyRobotLab and other versions (current 1.0.17.58)
If I try to connect Arduino uno clone, the program closes. It even turns off when selecting port. That's why I can't do anything. Can you help me where I went wrong?
So the question came up in the forums about repedative questions to the ProgramAB.
So I started to look at the call for starting and using the ProgramAB service.
 
In the Manticore version, this is the example code:
 
#########################################
# ProgramAB.py
#########################################
 

I currently have 1.1.518 installed

I see 1.1.523 is now the latest version.

I download and get a myrobotlab.jar

To install do I just paste the file into my directory (C:/MRL) over-writing the previous jar file and run it?

Showing a RasPi and Sabertooth motor control and the new config system.
After all the parameters where tweaked in the gui, they all were saved.
Later, just load it back and your ready to drive ....

 It has been a few days since I fired up MyRobotLab and it shows I'm at version 1.1.518. The latest build shows 1.1.523? I thought I read where MRL would auto update, is that correct?

Hmm probably should put sparkles in it.  Anyway this is the new NeoPixel2 interface so far.

Each pixel comes with its own color chooser, then there is a fill and select color chooser, and an controller, pin, pixel count and animation drop down.