Hi!
I'm a beginner in python and Myrobotlab, so sorry if it's a stupid question (and my bad english!).I'm trying to install, but it has the following error: 'could not open port com20 rate 115200 ...'. I already checked and this port is not being used. So why this mistake?
Tks!
Hi ! you need to upload
Hi ! you need to upload mrlcomm sketch into your arduino ( folder ressources/arduino/mrlcomm )
Hi!
Already Installed in Arduino Mega 2560, but not work! In Com7, this problem does not occur!what script do you use
what script do you use
This
MRLcoom.ino, the same one that is uncompressed when installed this version: MyRobotLab 1.0.1723 for Windows 64 bits (http://inmoov.fr/how-to-start-myrobotlab/)Port Setting
Are you sure you have configured the port in your script to point to the port the arduino is on?
Port setting
Hi,
Arduino is in COM3 in my PC.
In script InMoov3.Deep.AB.V7.py it is like this:
leftport = 'COM20'
rigthport = 'COM7'
This script need 2 arduino.
This script need 2 arduino. So 2 com ports
Port setting
Yes, both are installed, but the problem occurs in this COM20. And this COM is not being used. He says: 'could not open port COM20 rate 115200....'ok you have 2 arduino and you
ok you have 2 arduino and you upload mrlcomm inside those 2 arduino.
What is the COM ports of those 2 arduino . I think you have COM3 and ?
Forget about
leftport = 'COM20'
rigthport = 'COM7'
and chnage
leftport = 'COM3'
rigthport = '?'
Port setting
Now I get it! The leftport and rigthport has to be the same as the Arduinos. It is?Yes it is
Yes it is
Port setting
Great!!!!
youre welcome, have fun !
youre welcome, have fun !