I currently have 1.1.518 installed
I see 1.1.523 is now the latest version.
I download and get a myrobotlab.jar
To install do I just paste the file into my directory (C:/MRL) over-writing the previous jar file and run it?
Showing a RasPi and Sabertooth motor control and the new config system.
After all the parameters where tweaked in the gui, they all were saved.
Later, just load it back and your ready to drive ....
Hmm probably should put sparkles in it. Anyway this is the new NeoPixel2 interface so far.
Each pixel comes with its own color chooser, then there is a fill and select color chooser, and an controller, pin, pixel count and animation drop down.
Jim_K asked about how to start Nixie's InMoov2 simulator... so here it is:
InMoov2 version 1.1.518
java version "1.8.0_202"
Java(TM) SE Runtime Environment (build 1.8.0_202-b08)