Submitted by AutonomicPerfec... on Wed, 10/02/2019 - 08:52.
That depends entirely on your particular build and what you have set up. Are your servos rated for 12 or 5 volts? Are you connecting the Arduinos directly to this power supply via 5V or are you going to use the barrel jack (which can handle up to I believe 12V but it will increase heat output substantially going that high)? Do you have a Raspberry Pi or are you using a tablet/ mini-ITX? In general 11.1V Lipo would be fine, but you would need to do voltage regulation to bring down to a steady 5V for more sensitive components.
myrobotlab
That depends entirely on your
That depends entirely on your particular build and what you have set up. Are your servos rated for 12 or 5 volts? Are you connecting the Arduinos directly to this power supply via 5V or are you going to use the barrel jack (which can handle up to I believe 12V but it will increase heat output substantially going that high)? Do you have a Raspberry Pi or are you using a tablet/ mini-ITX? In general 11.1V Lipo would be fine, but you would need to do voltage regulation to bring down to a steady 5V for more sensitive components.
Got it.
Noted with thanks, I'll figure about it.