2. Install MRLComm.ino (this only needs to be done once - unless there is a new version) (Do this with the Arduino IDE)
3. Install all necessary service - many people just do System->update->Install Latest (this will install all services)
4. Use GUI - click on runtime tab - right click Arduino, name it arduino. right click on servo, name it servo - go to the service tab and attach it to the arduino on a pin - it should slide with the controller - if not - send a no-worky -> http://myrobotlab.org/content/helpful-myrobotlab-tips-and-tricks-0#noWorky
Hi Hoelzel For general
Hi Hoelzel
For general information the Tips & Tricks page may be useful -
http://myrobotlab.org/content/helpful-myrobotlab-tips-and-tricks-0
1. Get the latest MRL
2. Install MRLComm.ino (this only needs to be done once - unless there is a new version) (Do this with the Arduino IDE)
3. Install all necessary service - many people just do System->update->Install Latest (this will install all services)
4. Use GUI - click on runtime tab - right click Arduino, name it arduino. right click on servo, name it servo - go to the service tab and attach it to the arduino on a pin - it should slide with the controller - if not - send a no-worky -> http://myrobotlab.org/content/helpful-myrobotlab-tips-and-tricks-0#noWorky