Here's MultiWii running in the same process and MRL. I put in a couple serial hooks where I thought messages were going to go back and forth..  I was pretty surprised in that I thought you could control a quad copter with this program, but it looks like its primarily for reading telemetry & tuning your quad

I did not get any serial data from the places I thought I might.  I hooked up an Arduino Mega and loaded the MultiWii sketch then tried connecting .. I got a serial stream, but its not where I thought it was.

I also noticed that if I stopped an Animation Thread - the serial telemetry would stop.  So, the GUI IS the whole app... there is no clean division between serial functionality & gui - its all wrapped together..

I have lost some interest with this program for the following reasons :

  • no clean division between gui / functionality / serial protocol
  • not much if any "control" ability - you can not control your quad from it

Alessandruino

10 years ago

MRL isn the GUI ! :)

so we should proceed with the eziosoft EZ GUI app ?

I would be very happy to just have control over the serial..i don't use telemetry ... and you can add a separate telemetry to overlay to the video streaming which would be more usefull